Vinyl technikai adatlap
Digital White 6130 Series
2 year monomeric plasticized vinyl film
FACE MATERIAL: 6130 80μ White gloss, monomeric plasticized soft PVC film.
FACE MATERIAL: 6131 80μ White matt, monomeric plasticized soft PVC film.
FACE MATERIAL: 6132 80μ Transparent gloss, monomeric plasticized soft PVC film.
FACE MATERIAL: 6133 100μ White satin, monomeric plasticized soft PVC film.
P ADHESIVE : Permanent clear acrylic adhesive
R ADHESIVE : Removable clear acrylic adhesive
LINER : Clay coated Kraft liner 120 gsqm
Designed for the most commonly used large and extra-large printing equipment on the market.
Short to medium term indoor and outdoor promotion or advertising on flat or slightly curved surfaces.
General purpose pressure sensitive vinyl film for solvent based inkjet printing.
To achieve the best possible print quality, please make sure that the correct ICC profiles or
printer settings are used. Profiles can be downloaded, free of charge, from our web site
PHYSICAL PROPERTIES OF THE UNPRINTED FILM
|Adhesive Data, 23°C
Quick Tack on glass
Peel 24 hours on glass
|11,5 +- 4 N/25mm
14,0 +- 4 N/25mm
|3,5 +- 2 N/25mm
4,5 +- 2.,5N/25m
shrinkage : 48 hours at
70°C (applied on Alu)
|max 1.0 mm
applied on Alu panels
Minimum application t°:
Service t° range:
- 20°C to + 70°C
- 20°C to + 70°C
TDS 6130 series issue 4 JS Page 2 17/11/2010
2 years when stored at 15 to 25°C and 50 % relative humidity (in the original packaging).
The outdoor durability of the unprinted film is 2 years.
Overlamination of the inkjet printed material delays eventual colour fading that may occur upon
time. This colour fading is dependent from the quality of the inkjet inks and the self-adhesive
materials being used.
We recommend the use of our laminating films 6530 series.
Multi-Fix denies responsibility for product failure if non-Multi-Fix laminating films are used
for the application.
Always test the combination of Digital White print media, inks and laminating film prior to
Laminating conditions: Please ensure the print is perfectly dry. The printed material should be left
to dry for at least 48 hours prior to lamination or transport.
Don’t take shortcuts when drying graphics!
Drying of the graphics can be accelerated by passing a cold air flow over the print by means of
an air blower mounted at the bottom of a drying fan.
All Multi-fix products are subject to careful quality control throughout the manufacturing process and are
warranted to be of merchantable quality and free from manufacturing defects. Published information
concerning Multi-fix products is based upon research which the Company believes to be reliable although such
information does not constitute a warranty.
Because of the variety of uses of Multi-fix products and the continuing development of new applications, the
purchaser should carefully consider the suitability and performance of the product for each intended use, and
the purchaser shall assume all risks regarding such use. The seller shall not be liable for damages in excess of
the purchase price of the product nor for incidental or consequential damages.All specifications are subject to
change without prior notice.